Bronwyn asked: How do I remove tar (from new seal on road via bare feet!) from the bath and shower?
Table of Contents:
This black sticky goo seems to adhere to any surface and want to stick around for good. Fortunately, it can be removed with a few simple steps.
You Will Need:
- WD-40
- Green scrubbing pads or plastic scrubbers
- Dawn dish soap
- Soft cloths
- Water
- Tar Remover (available in the automotive section)
- Scrub brush
- Bucket
Steps to Remove the Tar:
- Start by spraying the tar with WD-40 and allowing it to soak for a few minutes.
- Fill a bucket with water and add some Dawn dish soap.
- Dip the scrubbing brush into the water and scrub the tar with the brush.
- Continue scrubbing until all of the tar is removed. Plastic scrubbers can also be used to remove the lubricated tar. If it will not come loose, add additional WD-40 and allow it to set a few more minutes.
- There are specially designed products for tar removal that can be found in the automotive department. Test a small, hidden area first to ensure that it does not damage the surface of the tub.
- Once the tar is removed, clean the entire tub as normal to remove any residue from the cleaning products.
Additional Tips and Advice
- Other lubricants can be substituted for the WD-40 if it is not available. Goo Gone, baby oil and vegetable oil will all provide lubrication to help in removing the tar.
- Ensure that all residue from the lubricant is removed before using the tub again. The smooth surface of the bath is slippery and the lubricants can make it a dangerous area to try and keep your balance.
- If the area with tar is large, work in small sections.
- Work in a well ventilated area and protect yourself with rubber gloves. Open the windows to allow fresh air to enter while cleaning.
